Using The Air Compressor - Ronix Rc-1012 Bedienungsanleitung

TURNING THE AIR COMPRESSOR ON/OFF
1) With the air compressor plugged in, pull the power switch to the ON
position to power the compressor on.
2) To turn the air compressor off, push the power switch to the OFF
position.
NOTE
When the compressor is in the ON position, the air compressor will
automatically turn back on when the designated tank air pressure
limit. It will also shut off again when the desired limit. It will also shut
off again when the desired pressure is reached.
WARNING!
Never exceed the air tool's pressure rating as recommended by the
manufacturer. When using this air compressor as an inflation device,
always follow the maximum inflation guidelines stated by the manufac-
turer of the item being inflated.
WARNING!
Always ensure the switch is in the OFF (O) position and the regulator
pressure gauge reads zero before changing air outlet. Failure to do so
could result in possible serious personal injury.

USING THE AIR COMPRESSOR

1) Ensure power switch is in OFF (O) position and air compressor is unplugged.
2) If not already installed, attach hose to compressor
3) Attach 6.35 mm (1/4 in.) NPT quick- connect air fitting to accessory or
tool you intend to use.
4) Insert the other end of the quick connect air fitting to the quick coupler
on the open end of hose.
5) Connect the power cord to the power supply.
6) Turn the switch ON (1).
26
Air Compressor 10 Liter