N-Gear RC 600 Bedienungsanleitung Seite 5

1. > button
Single click: to enter into next song
2. TWS button
Single click : to enter into /exit TWS function
1) Prepare two speaker ,single click this button for either of them,will hear a voice
prompt .(PS:Please make sure the speaker is disconnected with any wireless device
before using TWS function )
2)Then wait for a few seconds, will hear a voice prompt after the two speaker connected
with each other successfully. Search for the bluetooth ID to connect with bluetooth device.
3)After connected with bluetooth device, operate either speaker,the other one will be
synced.
4)Single click TWS button of either of them will exit TWS mode.
Long Press:To switch the music playing mode
The default playing mode of the device is bluetooth mode when turned on the device.
When TF card, U-disk, AUX all was inserted at the same time,long press this button each
time, the playing mode will be from TF card-U disk-AUX input , then back to bluetooth
mode. There will be voice prompt when switch each mode. (Note: This operation should
be under TF card, U-disk, AUX all insert on the speaker in advance)
3. Light button
Single click : to switch the light mode
Long press : to turn on /off the light
Double click: to enter into /exit bluetooth connection
4. Knob (Control the volume)
Rotate left to reduce the volume, rotate right to enlarge the volume
Single press : to pause /play the music
5. EQ button
Single click :Switch EQ mode ,three EQ mode :Bass mode /Normal mode /Karaoke
mode. There will be a voice prompt when switch the EQ mode
6. Power on /Power off button
Long press 3s :power on /power off
7. < button
Single click : go back last song
8. Type-c jack
Insert the type-c charging cable to charge the speaker
9.TF jack
When insert a TF card, the default playing is TF card playing mode
TF card support 32GB maximum
10.USB jack
When insert a U-disk , the default playing is U-disk playing mode
U-disk support 32GB maximum
11.AUX jack
Standard 3.5mm headphone jack