AFRISO FT4F-rw Betriebsanleitung Seite 28

Mounting
A
2. Push the locks (A) of the mounting
frame to the outside and remove
the holding plate (B).
3. Then remove the frame (C) from
the mounting frame.
For screw mounting, it is recommen-
B
ded to use tapping screws, counter-
sunk head (2.9 x 25 mm, DIN 7982
C), dowels (5 x 25 mm); mounting to
C
55 mm switch boxes.
4. Screw the mounting frame (D) to,
for example, a wall. Verify that the
locks (A) are at the top and the
bottom.
The frame can be replaced with a
frame with the same inside dimensi-
ons of a different manufacturer.
5. Fasten the frame (C) and the hol-
D
ding plate (B) to the mounting
frame (D).
FT4F-rw
EN
12