Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The "sampling rate" specifies the repetition rate of the data
logger. You can change this setting between "1 Second" (one
measurement per second) up to "12 hours" (a measurement
every twelve hours) in seconds, minutes and hours. Depending
on the "sampling rate" the maximum recording time changes.
Under "Alarm Setting" you can select a "high-alarm" for values
higher than a specified limit or "low-alarm" when it falls below a
freely set limit. This triggered alarm is indicated by a flickering
alarm LED, which is located above the LCD-display. In this
menu you can adjust the alarm settings for both Type-K probes
independently.
With "LED Flash Cycle Setup" you can set the "REC" LED
setting, which is lit during recording.
Under "Start Method" you can select when the data logger
starts recording. If you select "Automatic", the data recording
starts immediately when you remove the USB cable, and if
"Manual" you can start record by pressing any key on the data
logger.
-39-
Werbung
