Leatt REAFLEX CHEST PROTECTOR Bedienungsanleitung Seite 4

Verfügbare Sprachen

Leatt

Corporation's personal protective equipment is not designed or intended to protect a

wearer against serious bodily injuries caused by hard collisions or crashes. Protective equipment

such as stone shields offer protection only against lofted stones or debris. Protective equipment

such as back or lumbar protectors do not protect against spinal injury. No protective equipment

can protect the wearer from all foreseeable impacts.

Testing and Approval

The Leatt

Protector has been tested against the manufacturer's specifications and EU Type – Examination

certification has been issued by RICOTEST Via Tione, 9 - 37010 Pastrengo (VR), European Notified Body

No. 0498. It is CE marked to denote compliance with the Personal Protective Equipment Regulation (EU)

2016/425.

The following European Standards have been used in the evaluation of this product:

- EN 1621-2:2014 – "Motorcyclists' protective clothing against mechanical impact - Part 2: Motorcyclists'

back protectors"

- EN 1621-3:2018 – "Motorcyclists' protective clothing against mechanical impact - Part 3: Motorcyclists'

chest protectors"

- EN ISO 13688:2013 – "Protective clothing - General requirements"

Note: To view the Declaration of Conformity to PPE Regulation (EU) 2016/425 please navigate to leatt.com

and select the DOCUMENTS tab on your product's page.

Protection provided

Protector CE certified to PPE Regulation (EU) 2016/425

Chest protection conforms to the Level 1 requirements of EN1621-3:2018

Back protection conforms to the Level 1 requirements of EN1621-2:2014

Leatt

protector back plates have been tested to EN1621-2:2014 and recorded a mean transmitted force of

below 18kN from a 50 Joule impact (Level 1).

Leatt ® protector chest plates have been tested to EN1621-3:2018 and recorded a mean transmitted force of

below 18kN from a 50 Joule impact (Level 1).

Use

Products meeting the requirements of the technical specifications listed above are intended to reduce the

severity or incidence of soft tissue injuries such as bruising, contusions, cuts and abrasions during off-road

motorcycling and biking activities, such as Moto-X, Enduro, Downhill MTB, BMX and Adventure Sports.

- Products meeting the requirements of the technical specifications may reduce the severity and/or

incidence of some more serious injuries such as minor fractures.

- Products meeting the requirements of the technical specifications cannot significantly mitigate against

major injuries, such as serious fractures resulting from extreme impact forces or torsion/flexion/bending/

crushing injuries and neurological spinal injuries. Currently available materials and technology do not

allow this level of protection to be attained in products which would be acceptable to wear and which

would allow physical activities to be conducted and completed satisfactorily.

WARNING