Specifications - NGS black sani Bedienungsanleitung

Using the citrus juicer
The two cones have been designed to squeeze the juice from
citrus fruits of different sizes. Use the large cone to squeeze the
juice from large citrus fruits. For smaller fruits, remove the large
cone and use only the small one.
Change the size of the opening that lets the juice out by adjusting
the position of the top strainer in relation to the bottom one. If you
turn the handle control to the left, the size of the opening in the
strainer will be increased, as is shown below
CORD STORAGE
The power cord can be wound around the slot located in the base
for easy storage of the appliance when not in use. The plug also
fits into the bottom of the base, as is shown in the top diagram.

SPECIFICATIONS

Noise level: should be lower than 90 dB at a distance of 1 metre.
Before using the citrus juicer for the first time, clean it in
accordance with the instructions in the "Cleaning" section.
Connect the citrus juicer to the mains and adjust the position of
the top and bottom strainers to obtain the opening you require.
Cut the citrus fruit in half, place one half on the cone and press
down with enough force to make the motor start. Keep pressing
until the pulp has been squeezed from the fruit. The motor will stop
as soon as you stop pressing.
Once you have finished juicing, unplug the appliance from the
mains, remove the cone and the top and bottom strainers and pour
the collected juice into the jug.
Note
Do not use the citrus juicer continuously for more than one
minute.
EN
FR
ES
DE
IT
PT