Herunterladen Diese Seite drucken

Stalgast 786010V01 Bedienungsanleitung Seite 10

Verfügbare Sprachen

Verfügbare Sprachen

Thank you for your purchase of a Stalgast product. Before use please familiarize yourself in detail with the following
instruction. manual. Copying of the following manual without the consent of the manufacturer is prohibited. Images and
drawings are of illustrative character and may differ from the purchased product.
Attention: This manual should be kept in a safe place accessible for personnel. The manufacturer reserves the right to
change the technical characteristics of the product without any notice.
1. SAFETY INSTRUCTIONS
• Improper operation and misuse may cause serious damage to the unit or injury to persons.
• The device must only be used for the purpose for which it was designed.
• The manufacturer assumes no responsibility for damage caused by improper handling and use of the device.
• During use, protect the device and the power cord plug from contact with water or other liquids. In the event that the
device inadvertently falls into water, unplug it immediately and have the device checked by a specialist.
Failure to follow these instructions could result in life-threatening injuries.
• Never open the housing of the device yourself.
• Do not insert any objects into the housing of the unit.
• Do not touch the power cord plug with wet hands.
• Regularly check the condition of the plug and the cable. If you detect damage to the plug or cable, have it repaired by
a specialized repair facility.
• If the device falls or is otherwise damaged, always have it inspected and possibly repaired at a specialized repair fa-
cility before further use.
• Never repair the unit yourself - doing so may endanger your life.
• Protect the power cord from contact with sharp or hot objects and keep it away from open flames. If you want to di-
sconnect the device from a contact, always grasp the plug, never pull on the cable.
• Secure the cable (or extension cord) so that no one mistakenly pulls it out of contact or trips over it.
• Check the functioning of the device during use.
• Do not allow minors or persons without sufficient experience and knowledge to operate the device. The above-mentio-
ned persons may only operate the device under the supervision of a person responsible for safety.
• If the device is not currently in use or is being cleaned, always disconnect it from the power source by pulling the plug.
• Note: If the power cord plug is connected to a contact, the device remains live at all times.
• Turn the appliance off before you pull the plug out of the socket.
• Never pull the unit by the power cord.
2. HEALTH AND SAFETY RULES
• Do not overload the device.
• Unplug the device before adjusting, cleaning and maintenance. This will reduce the risk of accidental activation or
electric shock.
• The device should be protected from children.
• Repair and maintenance of equipment should be carried out by qualified personnel using only original spare parts.
• Do not remove factory-installed covers or tamper with the unit.
• When transporting or moving the device from storage to the place of use, observe health and safety rules.
• Clean the device before and after use.
• Install the equipment away from sources of fire and heat.
• Before starting the device, make sure that all moving parts are properly installed.
• It is forbidden to use the device without the bowl guard in place.
• Do not use hard, deep-frozen products, it may cause overloading and damage to the machine.
• Do not leave the machine unattended during operation.
• Do not move, rearrange, etc. the machine while in operation.
• Do not touch moving parts or accessories unless the machine has been disconnected from the power supply.
• Do not obstruct the ventilation openings of the machine!
2.1.  Before first use
Clean all food-contact parts with warm water and mild detergent and a cloth.
Then wipe thoroughly with clean water and dry the parts.
3. CONSTRUCTION OF THE DEVICE
3.1.  Purpose of the device
The device is designed for mixing and kneading.
- 10 -
loading