Service And Maintenance; Replacing Carbon Brushes - Ronix 2106B Bedienungsanleitung

the bit in the indentation and start drilling.
Use a cutting imbricate when drilling metals, the exceptions are iron and
brass which should be drilled dry.

SERVICE AND MAINTENANCE

- Always disconnect the tool before carrying out inspection or cleaning.
- Never use water or other liquids to clean the tool. Clean the tool by
brushing it with a brush.
- The air-vent of the tool should be cleaned regularly to avoid the motor
too hot due to air-vent blocked.
- Always check if the components of the tool are fixed well.
- The housing should be without track or damage.
- Always check if the cable is without damage.

REPLACING CARBON BRUSHES

-Replacing the carbon brushes when tool could not run or too much sparkle.
- Carbon brushes which are worn out (burned, broken or shorter than
5mm) have to be replaced by new ones.
- Always replace both carbon brushes at the same time and use the
brush by original manufacturer.
- Because the carbon brush is internal, so please change the brushes by
RONIX SERVICE maintenance service center.
- After placing the new carbon brushes, Let the tool run for some minutes
so that the brushes fit better.
REPAIRS
Please only use accessories and spare parts recommended by RONIX.
If the tool get malfunction, please hand over the tool to RONIX dealer
or appointed RONIX SERVICE maintenance station. Don't disassemble
the tool by yourself or replace the parts supplied by others.
13
User Manual