Herunterladen Inhalt Inhalt Diese Seite drucken

TCi T15-VGA Handbuch Seite 9

Inhaltsverzeichnis

Werbung

4.) Führen die Kabel durch den Rahmen und
die Öffnung des Deckels. Montieren Sie
den Gehäusedeckel an den Tragarm.
Bei Verwendung eines Tragarmsystems
müssen Sie beachten, dass das Gerät
rückseitig einen VESA 75 Anschluss hat
und ein Gesamtgewicht von ca. 6 Kg (je
nach technischer Ausstattung).
Achten Sie bei der Montage
!
darauf, dass die verwendeten
Schrauben nur max. 5 mm in das
Gehäuse eingeschraubt werden
dürfen, da sonst Komponenten
beschädigt werden können.
Bei den nächsten Montageschritten, ist es
notwendig eine weitere Person hinzu zuzie-
hen!
12x
5.) Verbinden Sie nun die Kabel mit den dafür
vorgesehenen Schnittstellen des LCD's in
der Front (VGA-MT: zusätzlich die Kabel-
verbindungen der Schalter). Eine Person
sollte die Front halten, die Andere schließt
die Kabelverbindungen zwischen Netzteil
und Front wieder an.
Fixieren Sie Kabel anschließend im Gehäu-
sedecken mit den beigelegten Klemmen zur
Zugentlastung.
!
6.) Montieren Sie abschließend die Front an
die Gehäusedeckel. Der Rahmen wird
dann von der Rückseite verschraubt.
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Seite 16 von 28
4) Insert the cables through the frame and
opening of the cover. Mount now the
cover to the mounting arm. By using an
mounting arm, you have to attend, that
the unit have on the rear side an VESA 75
connection and the weight approx. 6 kg
(depending on technical equipment).
Please attend by the moun-
!
ting, that the used screws don't
screwed more than 5 mm into the
chassis, because components
can be damaged.
By the next mounting steps you must work
together with a second person.
12x
5.) Connect the cables to the ports of the
LCD at the front (VGA-MT: connect the
cables to the operation parts). One person
has to hold the front, the other one have
to connect the power supply and the
front.
Fix now the cables into the cover with enc-
losed cable clips as strain relief.
6.) Please mount the front to the cover. The
frame must be bolt together from the
!
backside.
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Seite 17 von 28

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

4453T15-vga/mt

Inhaltsverzeichnis