Baxall DVSR Installations- Und Betriebsanweisungen Seite 4

For Safety
Please follow these instructions as you install your DVSR. Have them available
during the life-time of your DVSR, passing them on to subsequent users. If you have
any problems contact your Baxall agent.
WARNING: Installation is only to be carried out by competent, qualified
and experienced personnel
WARNING : Wire in accordance with the IEE wiring regulations, BS7671,
or a similar national standard which applies in the country of use.
Failure to do so can result in injury or death by electric shock
Baxall Security designed this product for use in general purpose CCTV applications.
Refer to your Baxall agent before installing or using your DVSR in medical and/or
intrinsically safe applications.
Do not exceed the voltage and temperature limits given in the specifications at the
back of this manual. Only use your DVSR in a clean, dry, dust-free environment
unless you are using an appropriate protective housing .
Glossary Definitions
Mains - this refers to the mains supply voltage labelled on your alarm input module
power supply
N/O - this refers to alarm relay contacts which are normally open when not alarmed
N/C - this refers to alarm relay contacts which are normally closed when not alarmed
PRODUCT SAFETY AND ELECTROMAGNETIC COMPATIBILITY (EMC)
This product is intended for use in general purpose CCTV applications in a
residential, commercial or light industrial EMC environment.
Refer to Baxall Security before installing or using the product in medical and/or
intrinsically safe applications or in an industrial EMC environment.
WARNING : This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
The product must be installed in accordance with good installation practice for EMC
to enable the product to function as intended and to prevent EMC problems. Refer to
Baxall Security for installation guidance.
Page 3