Operating Noises / Troubleshooting - exquisit EGS101-080E Gebrauchsanweisung

Operating noises / troubleshooting

13 Operating noises / troubleshooting
Repairs to electrical appliances must only be carried out by the customer service (see
chapter Ersatzteile / Kundenservice). Incorrect or improperly carried out repairs can be
dangerous for the user.
If the repair has not been carried out properly, the warranty will be invalidated.
Operating noise
NOISE
Normal noises
Troubleshoot
DISTURBANCE
Cooling group
starts too often
and for too long.
Unit does not
freeze properly.
Side wall is very
warm (only for
models with
foamed-in
condenser).
Page | 38
NOISE
Marbles
Liquid noise
Clicking sounds
Vibration of the
condenser (only with
visible condenser at the
rear of the unit)
POSSIBLE CAUSES
The appliance door is opened too
often.
Air circulation around the unit is
obstructed.
Unit is switched off or is not
supplied with power.
Temperature controller is set to
"OFF".
Ambient temperature is too low.
Door not closed tightly or door
seal is not fully open.
The condenser releases warm air
into the environment. If the
ambient temperature is too high,
heat can build up. As soon as the
ambient temperature has
dropped, the unit cools normally
again. It is essential to observe
the distances (see chapter Gerät
aufstellen).
CAUSE / REMEDY
Caused by the compressor when it is in
operation.
Arises from the circulation of the
refrigerant in the unit.
The temperature controller switches the
compressor on or off.
Check if the condenser at the back of the
unit is loose.
Fasten the condenser.
MEASURES
Do not open the appliance
door unnecessarily.
Leave the area around the unit
free.
Check the power supply and
fuses. Check that the mains
plug is correctly inserted in the
socket.
Check whether there is voltage
at the socket.
Check the temperature
controller settings.
(see chapter Gerät aufstellen)
(see chapter
Gerätetürdichtung reinigen /
wechseln).
No action necessary.