PCM BO26-RSE-210 Betriebsanleitung Seite 2

English
1. To fix the tool holder on the
machine, introduce the shank and
use the pin for positioning. Tighten
the 6 fixing screws (important, make
sure that the screws have the same
clamping force).
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BO26-RSE-210
2. Adjust
3. During the mounting or the dismounting
4.
MARK :
empty
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 04.03.2019
the offset of the position.
of your cutting tools, block the broach
on flats planned for that purpose.
The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet.
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
Never use the tool holder with
positions. Use
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document :
BO26-RSE-210 Mode
d'emploi
Page : 2 de 4
the supplied
office@pcm.ch