Vii.testing - Rapid Rm10N Installations- Und Anwenderhandbuch

VII. Testing
１ １ １ １ ． ． ． ． Inspection before use
A. Check installation of the whole machine and the pipe connections
according to the pipe connecting drawing;
B. Check the electric wiring according to the electric wiring diagram; and
earthing connection;
C. Make sure that the main machine power switch is off;
D. Check the temperature setting;
E. Check the air inlet and outlet.
２ ２ ２ ２ ． ． ． ． Trial
A. The user must "Start the Pump before the Machine, And Turn off the
Machine before the Pump", or the machine will be damaged;
B. The user should start the pump, check for any leakage of water; and then
set suitable temperature in the thermostat, and then switch on power
supply;
C. In order to protect the swimming pool heater, the machine is equipped
with a time lag starting function, when starting the machine; the blower
will run 1 minute earlier than the compressor;
D. After the swimming pool heater starts up, check for any abnormal noise
from the machine.
9