Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Using The iEP900 Power Bank
Charging the Power Bank
You can use the provided "USB to Micro USB cable" to charge the
iEP900 Power Bank from a USB power source. While the iEP900 Power
Bank is being charged, the white LED indicators will flash. When the
Power Bank is fully charged all LED indicators will light up and the
Power Bank will stop charging. Disconnect the Power Bank from the
power source and it is now ready for use. The charging process usually
takes around 7-8 hours via a 5V, 1.5A power source.
Recharging Your Devices
1. Using your original USB data cable or our standard cable, connect
the USB cable to the Power Bank USB Output.
2. Connect the other end of the cable to the device you want to
recharge.
3. To turn on the Power Bank, open the bottom cover and press the
power-on button. The LED Power Indicator will illuminate for 2-3
seconds showing the charger is on.
4. The Power Bank will automatically turn off after 30-35 seconds if it is
not connected to any device.
Battery Capacity Indicator & LED Light Switch Button
Press the power button to check remaining power
Power Status
LED Light( ● ON ○ OFF)
"○" LED indicator off
"●" LED indicator light on
○○○○
●○○○
●●○○
●●●○
●●●●
Capacity
<20% LED Flashes
20-40% Power
40-60% Power
60-80% Power
80-100% Power
3
Werbung
