Probuilder 44027 Gebrauchsanweisung Seite 11

Introduction
Thank you for choosing this electric drill/screwdriver from
PRO-BUILDER. PRO-BUILDER is a range of heavy-duty tools
for tradesmen and quality-conscious DIY enthusiasts. You
have purchased a high-quality and well-designed tool that
offers precision, durability and reliability. By following the
instructions in this User Guide, your drill/screwdriver will
provide many years of trouble-free use.
Please read this User Guide and the general safety instruc-
tions enclosed before using the machine, to ensure you get
maximum use from the tool. Keep the User Guide in a safe
place as you may need to refer to it at a later date.
Use
This powerful drill/screwdriver is ideal for working with a
range of materials, including wood, metal and plastics. Its
Akku function means that it can be used anywhere, even
when mains electricity is not available.
Technical specifications
Battery:
Speed: 0-340/990 RPM (depending on gear selected)
Internal diameter, drill chuck:
Weight:
Acoustic pressure:
Vibration level:
15 moment settings
29 assorted bits, 6 assorted drills, 8 assorted tops and 1
bit holder are included
Main components
18 V, 2000 mAh (model 44027)
or 3000 mAh (model 44028)
10 mm
72 dB(A)
< 2.5 m/s2
1. Self-tightening drill chuck
2. Moment selector
3. Direction selector
4. On/off button (infinitely variable)
5. Screw bit
6. Battery pack
7. Lock fastener
8. Strap
9. Softgrip handle
10. Ventilation slots
11. Gear selector
12. Magnetic screwholder
Special safety regulations
Use the battery charger at room temperature only (max. 40°
C).
Never use the battery charger if the battery, charger or cable
is damaged.
Check that the ventilation slots are not blocked.
Do not use damaged or worn bits and always select the
correct type of bit for the job.
1.8 kg
Secure small items in a vice or similar. Never hold the item
in your hand!
Check for concealed power cables, pipes etc in the items
or surface you are going to drill.
Place a piece of scrap wood under the item if possible.
Avoid the drill damaging objects under or behind the item,
e.g. when drilling in walls.
The drill must not be in contact with anything when starting
the tool.
Harmful dust can be caused when drilling certain materials.
Always wear a mask.
Ensure the machine is completely stopped before changing
direction.
Never put the machine down if the drill is still rotating. Wait
until it has stopped completely before putting it down if you
are not going to use it again.
Avoid touching the drill bit after use. It may be very hot.
Preparation and adjustment
Selecting direction
Select direction (left (L) or right (R)) using the direction selec-
tor switch (3). If the switch is in the middle, the machine will
not start.
Secting gear and moment
Select gear using the gear selector (11). In low gear, the motor
will run at 0-340 RPM. In high gear it will run at 0-990 RPM.
11
ENGLISH