Herunterladen
Teilen
Diese Seite drucken
  1. Anleitungen
  2. Marken
  3. SELF Electronics Anleitungen
  4. Stromversorgung
  5. SLD75-24VLD-E
  6. Bedienungsanleitung

SELF Electronics SLD75-24VLD-E Bedienungsanleitung

Vorschau ausblenden
1
2
Verfügbare Sprachen

Verfügbare Sprachen

Quicklinks

Diese Anleitung herunterladen
Instruction for the use of the
Dimmable LED Power Supply
Model: SLD75-24VLD-E
Applications
·This type of dimmable power supply is an exclusively designed stabilized
power supply for LED lamp. With constant voltage (CV) technology, it is
suitable for constant voltage lamps(24Vdc) connected in parallel. The
output current of the converter could be dimmed between 1%-100% by
DALI .
·The built-in protection circuit will shut down the power supply in case of
such faults as: open circuit, short circuit, over load or over temperature.
The power supply will restart after fault correction.
Important information for the installation
·The unit uses dangerous mains voltage(220-240VAC), it should only be
installed by qualified electricians according to European safety standards
or relevant nation regulations.Failure to observe any of the installation
instructions may cause fire or other hazards.
·The power supply is for LED lamps only. Pay attention to the polarity of
LED, wrong polarity may damage the LED.
·The power supply is only for indoor use and permissible operating
temperature is -20 to 45℃.
·With terminal cover and cable clamp, the power supply can be
The appearance of sketch
SELF Electronics Co.,Ltd.
No. 1345 JuXian Road, Ningbo Hi Tech Park, Ningbo, China 315103
independent installed.
·The indicated load should not be exceeded.
·The maximum length of the output cable to the LED lamps should not
exceed 2m in order to meet the EMC standard.
·If the LED power supply is used for purposes other than originally
intended or it is connected incorrectly, the manufacturer is not responsible
for possible damages.
Specifications
Input power :
85W
Input voltage :
220-240VAC
Input frequency :
50/60Hz
Input current :
0.38A
Input power factor :
0.95
Dimming mode :
DALI
Dimming range : 1%-100%
Constant output voltage : 24V
Output current :
0.08-3.13A
Rated output power :
2-75W
LED type :
COB or high power LED
Ambient temperature : -20...+45℃
Case temperature :
85℃
IP protecton :
IP20
Primary cable : 2X0.75mm
Secondary cable :
H03VVH2-F 2X0.75mm2 or
H03VVH2-F 2X1mm
Wiring diagram
2
or 2X1mm
2
2
loading

Verwandte Anleitungen für SELF Electronics SLD75-24VLD-E

Inhaltszusammenfassung für SELF Electronics SLD75-24VLD-E

  • Seite 2 Bedienungsanleitung für das ꞏDie maximale Länge des Sekundärkabels zur LED-Leuchte sollte 2 m nicht überschreiten, um die EMV-Standards zu erfüllen. dimmbare LED NETZTEIL Modell: SLD75-24VLD-E ꞏElektronische Altgeräte sind Wertstoffe und gehören nicht in denHausmüll. Bitte entsorgen Sie das Gerät gemäß den Anwendung örtlichenEntsorgungsregularien für „Elektronische Abfallprodukte”.