Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning (figure 2, page 3)
This spotlight may only be built into the wall of a pond with a liner if you use the
wall set WDM-50 (article no. 901044, not supplied).
To install the WDM-50, follow the instructions supplied with the WDM-50
wall conduit (art. no. 901044, not included).
Outside the pond, glue (C) a Ø 50mm glued socket (6) to the PVC pipe
(4).
Mount the cable seal (7) 900mm from the plug (2) on the cable (5) of
the spotlight. Make sure that the half-moons (11 + 13) of the cable seal
(7) are positioned crosswise opposite one another with the rubber seal
(12) in between. Make sure that the bolts can be tightened outside the
pond.
Run the cable (9) plug (2) from outside of the pond through the PVC
glued socket (6), PVC pipe (4) and wall conduit (3).
Tighten the four bolts evenly with the supplied Allen key (10) until the
cord seal (7) creates a watertight seal around the cord seal (7), the
glued socket (6) and cord (5).
Screw the plug (2) to the spotlight (1). Make sure that the plug (2) is
tightened securely.
If you wish to use the black rubber cover (14), place it on the spotlight
(1).
Fold the cable (5) in the PVC pipe (4) so that you can turn the spotlight
(1) in the wall conduit (3) by inserting it in the wall conduit (3) and
turning it clockwise until it stops turning and is secured in place (bayonet
catch).
Connect the protruding cable to a suitable transformer.
Thanks to the specified installation depth (A), PVC pipe length (4) and cable
length (5) dimensions, the light can simply be replaced by taking it out of the
water and inserting a new lamp.
With different installation depths (A), the length of the PVC pipe (4) and cable (5)
must be modified.
Maintenance
Before carrying out work on the spotlight, remove the plug of the
corresponding transformer from the socket. Observe the safety
instructions.
Clean the light with warm water and a soft-bristle brush or rag. Make sure no
water gets inside the lamp housing.
Note: the LED has a long service life, but is not replaceable.
Winter period
Protect the light from frost and freezing in water, as this may cause
damage.
If not installed deep enough under the water level, take the lights out of
the water for the frost period.
Store in a clean, dry and frost-free area.
English
www.auga.nl
14
Werbung
