Foot Control; Installation - Nakanishi SurgicPro Bedienungsanleitung

3-3 Foot Control

(b) PRG (Program) Button
(a) Coolant Solution Flow
Volume Button
(a) Coolant Solution Flow Volume Button
Use to select 6 levels of coolant solution flow from 0 to 5; each level may be increased by one step pressing this
button. If you press this button in level 5, it returns to level 0.
(b) PRG (Program) Button
Use to select the desired program number. Program numbers will always ascend each time this button is pressed and
released. To descend, press and hold for 1 second then release.
(c) Speed Control Pedal
Use to start and stop the Micromotor and to control the speed during operation. The Micromotor operational speed is
directly proportional to the position of the foot control, up to the preset maximum.
(d)
Forward/Reverse Button
Use to change the rotational direction of the Micromotor. Push once to change the rotational direction.

4. Installation

• Install the cord/plug only power is OFF.
CAUTION
4-1 Connecting the Motor Cord
Align the [ ] mark on the Motor Cord with [
●
Control Unit.
Push the Base of Motor Cord Plug into the socket until the
locking joint 'clicks' into place.
To disconnect the plug; pull back the Lock Joint, pull further
to disconnect the cord.
(c) Speed Control Pedal
] mark on the
●
Lock Joint
7
Foot Control Cord and Plug
(d) Forward/Reverse Button
[ ] mark
●
Fig.1