Battery Information; Cold Weather Usage - Sinkeu R300 Benutzerhandbuch

Battery information

Your device has an internal, non-removable, rechargeable battery. Do not attempt to remove the
battery.
The battery can be charged and discharged over 1000 times, but it will eventually wear out.

Cold Weather Usage

Cold temperature (below freezing) can affect the unit' s battery capacity due to chemical
characteristics of the battery. If you' ll be living off-grid in sub-zero conditions, we recommend you
keep your unit in an insulated cooler, and connected to a power source (solar panels). The natural
heat generated by the unit contained in an insulated cooler will keep battery capacity at its highest
condition.
Recycle
Please return your used electronic products, batteries, and packaging materials to dedicated
collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of
materials.
Statement
I. FCC Statement:
The operation meets the following two conditions:
(1) The equipment will not cause harmful interference
(2) The equipment must accept any interference received, including interference that may result in
accidental operation.
Note: The equipment has been tested and meets the restrictions of Category B digital equipment in
Part 15 of FCC Rules.
These restrictions are designed to provide reasonable protection against harmful interference in
housing installation.
This equipment will generate, use and radiate radio frequency energy. If it is not installed and used
according to the instructions, it may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation.
If the device does cause harmful interference to radio or television reception (which can be
determined by switching off and switching on devices), users are advised to attempt to correct the
interference by one or more of the following measures:
Re-adjusting or placing the receiving antenna.
Increase the distance between the device and the receiver.
Connect the device to a different circuit outlet from the circuit connected to the receiver.
Consult distributors or experienced radio/television technicians for help.