Herunterladen Inhalt Inhalt Diese Seite drucken

Riverside TP3B Anleitung Und Teileliste

Selbstansaugende schmutzwasserpumpe
Verfügbare Sprachen

Verfügbare Sprachen

TP3B
UTL1537Y
TP3H
UTL1602Y
TP3Y
UTL1630Y
TP3B-BSP
UTL1537YB
TPB-BSP
UTL1602YB
TP3Y-BSP
UTL1630YB
SYMBOL DEFINITION
Do not pump flammable materials. Fire could occur.
Do not pump hazardous material.
Read your product literature before use.
Do not smoke or bring flame near gasoline.
Disconnect spark plug before performing
maintenance, adjustment, lubrication, and
storage.
SAFETY PRECAUTIONS
• This pump is designed for pumping clean water only. It should not be
used to pump sandy water or hazardous fluids.
• Before start-up, study all of the instructions in this manual. Be sure
you thoroughly understand how to operate the pump. Proper
preparation, operation and simple maintenance will improve operator
safety, pump performance and long unit life.
• Be sure that each person who operates the machine is properly
instructed as to its safe operation.
Part No. L19959 Rev. E 2009/11/18
SELF-PRIMING TRASH PUMP
MODEL / UT NUMBER / DESCRIPTION:
3-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE
3-INCH TRASH PUMP, HONDA GX240 ENGINE
3-INCH TRASH PUMP, YANMAR DIESEL ENGINE
3-INCH TRASH PUMP, BRIGGS & STRATTON ENGINE, BSP NIPPLE CONNECTIONS
3-INCH TRASH PUMP, HONDA GX240 ENGINE, BSP NIPPLE CONNECTIONS
3-INCH TRASH PUMP, YANMAR DIESEL ENGINE, BSP NIPPLE CONNECTIONS
INSTRUCTIONS & PARTS LIST
• Always keep the machine and associated equipment clean, properly
serviced and maintained according to the instructions in this manual.
• Observe all safety regulations for the safe handling and storage of
fuel. Handle fuel in approved vented fuel cans. Do not store fuel
supplies in a garage, shed or other areas attached to living quarters.
Do not refill the fuel tank in an area attached to living quarters. Do not
refill the engine while it is running or hot. Carefully clean up any
spilled fuel before starting the engine.
• Do not smoke or bring flame near gasoline.
• Do not operate the pump at shut-off pressure for more than 2 minutes.
• Do not operate this pump if any safety equipment or guard has been
removed.
• Never operate the machine in any explosive atmosphere, near
combustible materials, or where there is not enough ventilation to
carry off the exhaust fumes. DO NOT operate pump indoors or in crawl
spaces.
• Always be sure the machine is on secure footing and cannot shift to
where it might injure someone. Remember that the suction hose on
the pump tends to pull the pump towards the liquid source during
pumping.
• Keep the immediate area free of bystanders.
• When pulling the starter, be sure that nothing is in a position to be hit
by the operator's hand or arm, or the starting rope.
• Do not touch the hot cylinder and muffler area.
• Shut off the engine and disconnect the spark plug wire before working
on any part of the machine.
• Long or continuous exposure to high noise levels, such as the
operation of a gasoline engine, may cause permanent hearing
impairment or other possible effects. Hearing protection devices are
available from your dealer, or can be ordered through him.
• Use only genuine product manufacturer's replacement parts. Failure
to do so may cause poor fit and possible injury.
• BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.
BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.
BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.
BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.
BEWARE OF USING THIS EQUIPMENT IN CONFINED SPACES.
Confined spaces, without sufficient fresh air ventilation, can contain
dangerous gases. Running gasoline engines in such environments
can lead to deadly explosions and/or asphyxiation.
Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Riverside TP3B

  • Seite 10: Anleitung Und Teileliste

    SELBSTANSAUGENDE SCHMUTZWASSERPUMPE MODELL / UT NUMMER / BESCHREIBUNG: TP3B UTL1537Y 3" SCHMUTZWASSERPUMP, BRIGGS & STRATTON MOTOR TP3H UTL1602Y 3" SCHMUTZWASSERPUMP, HONDA GX240 MOTOR TP3Y UTL1630Y 3" SCHMUTZWASSERPUMP, YANMAR DIESEL MOTOR TP3B-BSP UTL1537YB 3" SCHMUTZWASSERPUMP, BRIGGS & STRATTON MOTOR, SCHLAUCHANSCHLÜSSE - BSP...
  • Seite 11: Auspacken Der Pumpe

    AUSPACKEN DER PUMPE BETRIEBSANLEITUNG Achten Sie sorgfältig auf Versandschäden. Wenn Sie irgendeinen 1. Verwenden Sie ein Sieb am Ende der Saugleitung. Schaden bemerken, benachrichtigen Sie Ihren Händler oder den 2. Stellen Sie sicher, dass alle Schlauch- und Rohranschlüsse luftdicht Spediteur. Entfernen Sie alle Versandblöcke und Klammern. Wenn das sind.
  • Seite 12: Wartung Des Propellers Und Der Dichtung

    WARTUNG DES PROPELLERS UND DER DICHTUNG Ist die Leistung der Pumpe herabgesetzt, kann dies auf eine Abnutzung des Propellers oder der Dichtung hinweisen. Um das Gerät zur Wartung bzw. Reinigung auseinanderzunehmen, entfernen Sie die vier Abnahmegriffe, drehen diese zur Seite und nehmen das Gehäuse sowie das Propellergehäuse von der Pumpe ab.
  • Seite 13: Eingeschränkte Garantie

    EINGESCHRÄNKTE GARANTIE Riverside Pump Manufacturing Inc. garantiert gegenüber dem ursprünglichen Käufer, dass dieses Produkt von Riverside Pump Manufacturing Inc. frei von Material- und Fertigungsfehlern ist, und erklärt sich damit einverstanden, nach eigenem Ermessen von Riverside Pump Manufacturing Inc., defekte Produkte...

Diese Anleitung auch für:

Tp3hTp3yTp3b-bspTpb-bspTp3y-bsp

Inhaltsverzeichnis