Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IV. USER MANUAL
1. Charging.
a) Fully charge the battery before using it for the first time.
b) While the battery is charging, the battery level indicator LEDs will flash. When the battery is fully
charged, all 4 LEDs will be blue.
c)
A full charge takes about 4 hours.
d) When the battery level drops below 10%, the red LED will flash. The device should then be charged.
e) For safety reasons, do not use the device while it is charging.
f)
To ensure a long life, please charge the device when the red light starts flashing.
2. Replacing the massage heads.
a) Remove the caps when the appliance is switched off by pulling and twisting slightly.
b) Attach the attachments when the device is turned off, pushing firmly until the component is seated.
c)
Attach the vibrating belt holder with the thread, screwing it to the head of the massager as far as it will
go. Attach the vibrating belt using the available Velcro to the massager mount and the handle.
3. ON / OFF.
a) Press and hold the button for 3 seconds to turn on the device.
b) Press and hold the button for 3 seconds to turn off the device.
4. Speed adjustment.
a) Level 1 will be set by default when the device is turned on.
b) Each press will increase the speed to a higher level.
c)
When the speed reaches level 6, press again to return the speed to level 1.
d) Each level (1-6) corresponds to the set speed of the device:
(1) 1200rpm, (2) 1520rpm, (3) 1850rpm, (4) 2160rpm, (5) 2500rpm, (6) 2800rpm.
5. Heating level adjustment.
The device is equipped with an additional heating function carried out by 2 metal elements located in the
lower part of the massager. This function can be used, for example, as a muscle warm-up before a vibration
massage.
a) Level 1 will default to when the heating function is turned on, the heating function will turn off the
vibration function at the same time.
b) Each press of the adjustment button will increase the speed to a higher level.
c)
When the speed reaches level 3, press again to return the speed to level 1.
d) Each heating level shown on the display (H1, H2, H3) corresponds to the set temperature:
H1 – około 40°C, H2 – około 50°C, H3 – około 60°C. Warm-up time to 40°C is approximately
2 minutes
03
Note: The device is equipped with a 10-minute work timer to avoid muscle and fascia damage caused by over-
massage.
Speed display
Power indicator
Heating button
ON / OFF
EN
7
Werbung
Inhaltsverzeichnis
