Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
This fixture can be built into various sorts of decorative paving, such
as concrete or natural stone, or wooden constructions such as deck-
ing, walls, fences, pond edges etc.
General Installation Guideline
During installation, make sure that all components are easily acces-
sible for replacement.
Step 1
For installation in wood use a suitable saw/drill to saw/drill holes with
a diameter of 22 mm / 0.87 inches. If working with stone or similar ma-
terials, use a diamond drill bit (Ø 22,4 mm / 0.88 inches), available from
your dealer. Drill holes where appropriate before beginning to fit the
fixture. (Fig. 1)
Step 2
Feed the connector for the fixture through the hole and then carefully
insert the fixture into the recess. Use a clean synthetic hammer to do
this. (Fig. 2)
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 3)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 4)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3, 4 and 5. When the fixture is connected to
the main cable also check that the contacts of the Easy-Lock connec-
tor are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Werbung
