Remote Control Operation - Rnd Power Rnd 320-00162 Bedienungsanleitung

When connected to any appliance, be sure to turn on inverter first. And then turn on the
power switch of the appliance.
OPTIONAL ACCESSORY: REMOTE CONTROL

REMOTE CONTROL OPERATION:

When connected to any appliance, be sure to turn on inverter first. And then, connect
with the remote control well and turn on the switch of remote control.
CAUTION : DO NOT REVERSE INPUT.
Use red battery cord to connect (+) of a dc battery to (+) terminal. And then, use black
battery cord to connect (-) battery to (-) terminal.
5
EN
CHASSIS EARTH:
The chassis earth lug should be connected to an earth point, which will vary depending
on where the power inverter is installed. In a vehicle, connect the chassis ground lug
to the chassis of the vehicle. In a boat, connect to the boat's ground system. In a fixed
location, connect to earth.
When the inverter operates in full output capacity for a long period, the temperature
of the inverter will increase and potentially shut down by the over-temperature
protection. Therefore, it is recommended to reduce the ac output capacity if a long
continuous operating time is required.
Condition
Input Over Voltage
Lower Battery Alarm
Overheating Alarm
Overload Alarm
Note: BEEE is a 2-sec long beep, BEE is a 1-sec long beep, BI is a short beep
Warning Signal Cycle Shutdown Signal Cycle
No Warning Signal Continuous Tone
BEEE (Cycling) Continuous Tone
BEE (Cycling) Continuous Tone
BI (cycling) Continuous Tone
EN
6