Seben Deep Target Bedienungsanleitung Seite 8

Important information for preventing damages upon assembly:
Before delivery, the metal detector is tested and measured to guarantee full
functionality. Assembling the metal detector wrong or overhasty can damage or
sever the interior cables. Therefore please assemble it slowly and carefully!
Reparations of defects caused by wrong assembly will be made at the owner's
expense!
Thus please especially take care that the upper and lower part of the shaft are
connected correctly: the cut-out on the lower part has to face upwards, into
the direction of the controlling unit which can be found on the upper part of
the shaft. This cut-out shall protect the cables in the shaft from being severed
or damaged. The parts have to be pushed together in their correct position!
If you do not mind this small, but nevertheless important fact, you may damage the
cables. This may lead to malfunctions of the detector, e.g. loose contacts or even
non-function. To check whether the cables are cut or damaged, please remove the
controlling unit by releasing the small screw.
Detailed instruction how to assemble the Deep Target metal detector:
•
Remove the big plastic-headed screw (1) on the upper part of the shaft
(A).
•
Release the small screw (2) which connects the upper part of the shaft
with the controlling unit (C) - slightly, but not completely.
•
Connect both ends of the cables and mind the correct assembling of plug
and socket (3). Small arrows on both point out in which position they are
connected correctly. Wrong assembling may damage the cables.
•
Let the lower part of the shaft (B) slide slowly onto the upper part in
direction of the controlling unit. Mind the position of the cut-out as
written above! The cables run through this spot of the upper shaft part to
the controlling unit (5). Wrong positioning of the parts while assembling
will damage the cables!
•
After you connected both shaft parts correctly, tighten the small screw (2),
than refit the big plastic-headed screw into the hole on the rearside (6) and
tighten it as well.
- 8 -
Attention!
- Please read before assembling -