Siko RTX500 Benutzerinformation Seite 3

User Information
RTX500
Radio Transmitter/Receiver
ENGLISH
1. Warranty information
• In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and
the operating reliability of the device.
• Your device has been quality controlled, tested
and is ready for use. Please observe all warnings
and information which are marked either directly
on the device or specified in this document.
• Warranty can only be claimed for components
supplied by SIKO GmbH. If the system is used
together with other products, there is no warranty
for the complete system.
• Repairs should be carried out only at our works.
If any information is missing or unclear, please
contact the SIKO sales staff.
2. Identification
Please check the particular type of unit and type
number from the identification plate. Type number
and the corresponding version are indicated in the
delivery documentation.
e.g. RTX500-0023
3. Summary description
The RTX500 is an interface module with receive
function (optionally, send function) for wireless
communication with the radio-based electronic
RTX500 Datum 18.05.2009
Design ES
Design H
version number
type of unit
display MA503WL. Up to ten MA503WL units can
be operated with one RTX500.
Technical data:
Power supply: 24VDC ±20%
Power consumption: < 1VA
Radio frequency: 868 ... 870 MHz,
902 ... 928 MHz (USA)
Receive sensivity: -111 dbm
Protection: no politary inversion protection
Interface: RS232 / RS485
Working temperature: 0° ... +60°C
Storage temperature: -20° ... +70°C
Humidity: condensation not permitted
4. Installation
For mounting, the degree of protection specified
must be observed. If necessary, protect the unit
against environmental influences such as sprayed
water, dust, knocks, extreme temperatures.
The RTX500 is intended for mounting on a top-hat
rail, e.g. acc. to DIN EN 50022, DIN EN 50035.
• Hang the device onto the reil and snap on.
• For detaching the RTX500, hook in a screwdriver
below and losen the clamping in the direction
of the arrow.
Fig.1: Installation/ removal
Note: When integrating the RTX500 into a metalic
casing (e.g. a switchboad), we recommend lea-
ding the antenna outside via a BNC-extension line
and a BNC switchboard feedthrough for getting
maximum coverage.
5. Electrical connection
• Wiring must only be carried out with power off.
• Provide standed wires with ferrules.
• Check all lines and connections before switching
on the equipment.
Art.Nr. 82470 Änd. Stand 155/09 3