Fill Level Indicator; Water Flow Adjustment; Pre-Cleaning Advice - Numatic TT 1840 Bedienungsanleitung

Fill Level Indicator

Fill the clean water tank to a maximum of 18 litres, including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
Use the fill indicator
(Fig 12).
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturer's safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturer's specification.
For further guidance on hazardous substances refer to health and safety instructions online.

Water Flow Adjustment

Fig 14

Pre-cleaning advice.

Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig 16).
Numatic part (629044) Wet Floor sign
(available if required)
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
Fig 12
Showing the clean-water tank empty
Fig 15
45
0
Fig 13
(Fig 13).
Located on the left of the machine is the On / Off water tap
(Fig 14 / 15).
10
Machine Set-Up
Showing the clean-water tank full
(Fig 13a).
Fig 13a
!
Fig 16
!