Über diese Anleitung Diese Anleitung beinhaltet Informationen zur optimalen und sicheren Montage und Wartung des Dachventilators DV-2. Lesen Sie sich bitte, bevor Sie mit den Arbeiten beginnen, diese Anleitung sorgfältig durch. Diese Anleitung bezieht sich auf folgende Typen: DV-2 types:...
Nutzung gemäß Zweckbestimmung Der DV-2 dient dazu, verbrauchte Luft mit temperaturen zwischen -30°C und + 60° aus dem Gebäude abzusaugen. Der DV-2 ist nicht zum Absaugen aggressiver Dämpfe und hoher Temperaturen geeignet. Jede sonstige oder weitergehende Nutzung gilt als nicht mit der Zweckbestimmung konform. Der Hersteller übernimmt für sich hieraus ergebende Schäden oder Verletzungen keinerlei Haftung.
Sicherheit Es ist bezüglich der Sicherheit von großer Wichtigkeit, dass Sie die unten genannten Sicherheitsvorschriften beachten. Dies dient einer verantwortungsbewussten Nutzung des DV-2 sowie Ihrer eigenen und der Sicherheit anderer. • Bitte beachten Sie die in dieser Anleitung genannten Vorschriften und Anweisungen.
Nichtverwendung der Kabeleinführung diese mit einer Kappe versehen, damit kein Wasser in die Einführung laufen kann. • Der DV-2 muss gemäß den vor Ort geltenden Vorschriften angeschlossen werden. • Der Ventilator ist für einen kontinuierlichen Betrieb konzipiert und darf nicht öfter als einmal alle fünf Minuten ein- und ausgeschaltet werden.
Elektrischer Anschluss Allgemeines Der DV-2-Ventilator ist mit einem EC-Motor ausgestattet. Dieser Motor ist mit Elektronik ausgestattet. Diese Elektronik schützt den Motor beispielsweise gegen eine Überlastung. Dadurch bedingt ist kein Motorschutzschalter erforderlich. Die Leitung muss mit einem Leistungsschalter des Typs C abgesichert werden.ö...
Inspektion und Wartung Der Ventilator muss regelmäßig (einmal alle zwei Jahre) überprüft werden. Dies ist von der Verschmutzung der abgesaugten Luft abhängig. Die Inspektion muss, wenn starke Verschmutzung auftritt, öfter erfolgen. Explosionsdarstellung DV-2 Schutzgitter Motorhaube Obere Abdeckung Ventilatorrahmen EC-Motor + Diagonallauffrad Untere Abdeckung Fuß...
Inspektion und Wartung Wartung 1. Den Ventilator ausschalten. 2. Die Abdeckkappen der oberen Abdeckung entfernen. 3. Die Schrauben der oberen Abdeckung losdrehen. 4. Die Muttern der oberen Abdeckung losdrehen. 5. Die obere Kappe entfernen. 6. Das Schutzgitter entfernen. 7. Die Motorhaube entfernen. 8.
Konformitätserklärung - Original-Konformitätserklärung - EG-KONFORMITÄTSERKLÄRUNG Aussteller: Wolf GmbH Anschrift: Industriestraße 1, DE-84048 Mainburg Produkt: Klimagerät Produkttyp: DV-2 Serien-Nr.: siehe Typenschild am Gerät Das oben beschriebene Produkt ist konform mit den Anforderungen der folgenden Dokumente: Einschlägige EG-Richtlinien: Dokument-Nr. Titel Ausgabe 2006/42/EG...
Logbuch In der Tabelle die durchgeführten Arbeiten eintragen. Datum Auftrags-Nr. Firma Monteur Reklamation Anmerkung 3064772_201602...
Seite 13
Guide de montage et d’utilisation Ventilateur de toit DV-2 Wolf GmbH • B.P. 1380 • D-84048 Mainburg • Tél. +498751/74-0 • Fax +498751/741600 • Internet : www.wolf-heiztechnik.de N° d’article : 3064772_201602 Sous réserve de 3064772_201602...
Seite 14
Montage ........................18 Raccordement électrique ....................19 Généralités ........................19 DV-2 ..........................19 Inspection et Entretien ....................... 20 Vue éclatée du DV-2 ....................20 Inspection et Entretien ....................... 21 Entretien ........................21 Attestation de conformité ....................22 Registre ..........................23...
À propos de ce guide Ce guide contient des informations pour l’installation optimale et sûre et l’entretien du ventilateur de toit DV-2. Veuillez lire attentivement ce guide avant de commencer les travaux. Ce guide concerne les types suivants: DV-2 types:...
Utilisation conforme à la destination Le DV-2 a été conçu pour l’aspiration de l’air pollué hors d’un bâtiment. Le DV-2 n’est pas approprié pour l’aspiration de vapeurs agressives et de températures élevées. Toute autre utilisation ou un usage abusif ne sera pas considéré comme conforme à...
Sécurité En ce qui concerne la sécurité, il est très important que vous teniez compte des consignes de sécurité ci-dessous. Ceci pour une utilisation responsable du DV-2, ainsi que pour votre sécurité personnelle et celle des autres • Tenez compte des consignes et indications reprises dans ce guide.
Le DV-2 doit être transporté à l’horizontale. • Si le DV-2 est stocké, il doit être placé à l’horizontale. • Le DV-2 doit être soulevé par la partie inférieure de la boîte. • L’emballage doit être enlevé de manière écologique. Montage •...
Raccordement électrique Généralités Le ventilateur DV-2 est équipé d’un moteur EC. Ce moteur est équipé d’éléments électroniques. Ces éléments électroniques protègent par exemple le moteur contre la surcharge. Un interrupteur du circuit de courant électrique du moteur n’est donc pas nécessaire. Le fil doit être protégé par un automate de fusibles de type C.
Le ventilateur doit être contrôlé régulièrement (une fois tous les deux ans). Ceci dépend de la pollution contenue dans l’air de ventilation aspiré. Si l’air est fortement pollué, l’inspection aura lieu plus souvent. Vue éclatée du DV-2 Grille de protection...
Inspection et Entretien Entretien 1. Débranchez le ventilateur 2. Enlevez les chapeaux d’obturation de la coupe du haut 3. Dévissez les vis de la coupe du haut 4. Dévissez les écrous de la coupe du haut 5. Enlevez le couvercle du haut 6.
Attestation de conformité - Original de la déclaration de conformité - déclaration de conformité CE Emetteur: Wolf GmbH Adresse: Industriestraße 1, DE-84048 Mainburg Produit: Centrale de traitement d‘air Type de produit: DV-2 N° de série: voir plaque signalétique sur l’unité...
Registre Complétez le tableau des travaux effectués. Date Commande n° Société Technicien Réclamation Remarque 3064772_201602...
Seite 24
Installation and Operation Instructions Roof Mounted Exhaust Fan DV-2 Wolf GmbH • Postfach 1380 • D-84048 Mainburg • Tel. +498751/74-0 • Fax +498751/741600 • Internet: www.wolf-heiztechnik.de Art. no.: 3064772_201602 Subject to change 3064772_201602...
Seite 25
Table of Contents Content About these instructions………………………………………………………………………..26 Use products only as intended………………………………………………………………...27 Safety……………………………………………………………………………………………28 Installation………………………………………………………………………………………29 Transport, storage and unpacking………………………………………………………...29 Installation…………………………………………………………………………………...29 Electrical connection…………………………………………………………………...…..…30 General……………………………………………………………………………...……..30 DV-2…………………………………………………………………………………………...30 Inspection and maintenance…………………………………………………………………..31 Exploded view DV-2…………………………………………………………………….…...31 Maintenance……………………………………………………………………………..…...32 Declaration of conformity………………………………………………………………………33 Log………………………………………………………………………………………….…..34 3064772_201602...
About these instructions These instructions contain information for the optimal and safe installation and maintenance of the DV-2 roof mounted exhaust fan. Before beginning, read through all of these instructions carefully. These instructions apply to the following models: DV-2 types:...
Use products only as intended The DV-2 is meant for extracting polluted air from the building. The DV-2 is not intended to be used for extracting damaging vapors and high temperatures. Any application other than that listed shall be considered to be improper use.
Safety For safety reasons, it is very important that you follow the following safety precautions. This ensures a responsible use of the DV-2, as well as your own safety and that of others. • Follow the rules and instructions listed in this guide.
Transport, storage and unpacking • The DV-2 must be transported horizontally. • If the DV-2 is placed in storage it should be stored in a horizontal position. • The DV-2 must be lifted from the bottom side of the box. •...
Electrical connection General The DV-2 fan is equipped with an EC motor. This motor is equipped with electronic components. These electronic components protect the motor against e.g. overloads which means that a motor protection switch is not necessary. The power wire must be protected by a type C circuit breaker.
The fan should be inspected regularly (once every two years). This depends on the level of pollution in the extracted ventilation air. If there is a lot of pollution, the inspection should be done more often. Exploded view of DV-2 Protection Grille...
Inspection and Maintenance Maintenance 1. Switch the fan off 2. Remove the screw caps from the upper shell 3. Unscrew the screws from the upper shell 4. Unscrew the bolts from the upper shell 5. Remove the upper shell 6. Remove the protective grille 7.
Declaration of conformity - Original declaration of conformity - EC declaration of conformity Drawn up by: Wolf GmbH Address: Industriestraße 1, DE-84048 Mainburg Product: Air handling unit Product type: DV-2 Serial no.: see type plate on the appliance The product described above conforms with the requirements of the following documents: Relevant EU directives: Document no.