RND power RND 320-00170 Bedienungsanleitung Seite 3

DON' T MODIFY OUR CABLE ACCESSORY.
WHEN CONNECTED TO ANY APPLIANCE, BE SURE TO CONNECT THE
CIGARETTE PLUG FIRST. AND THEN TURN ON THE POWER SWITCH OF
THE APPLIANCE.
WHEN THE INVERTER OPERATES IN FULL OUTPUT CAPACITY FOR A
LONG PERIOD, THE TEMPERATURE OF THE INVERTER WILL INCREASE
AND POTENTIALLY SHUT DOWN BY THE OVER-TEMPERATURE
PROTECTION. THEREFORE, IT IS RECOMMENDED TO REDUCE THE
AC OUTPUT CAPACITY IF A LONG CONTINUOUS OPERATING TIME IS
REQUIRED.
WARNING SIGNAL (THE RED LED INDICATOR)
Condition Warning signal cycle
Input Over Voltage No Warning Signal
Low battery alarm: BI BI BI (pause)
Overheating alarm: BI BI (pause)
Overload alarm: BI BI BI BI BI BI(continuous)
Note: BI is a short beep, and BEE is a long beep.
3
EN
Shutdown signal cycle
BEE BEE BEE BEE.
BEE BEE BEE (pause)
BEE BEE (pause)
Continuous tone
DURING OPERATION, WHEN THE POWER SWITCH IS ON, IF POWER
ON NDICATOR IS NOT LIGHTED. PLEASE CHECK THE FUSE IN THE
CIGARETTE PLUG. IF THE FUSE IS SPOILT, FOR REPLACEMENT, USE
THE SAME CURRENT FUSE.
WHILE USING USB PORT: OUTPUT 5VDC (2.1A MAX) FOR CHARGING,
PLEASE CONNECT THE CIGARETTE PLUG FIRST, THEN CONNECT THE
USB WIRE TO THE ELECTRONIC APPLIANCE THAT NEEDED TO BE
CHARGED
WARNING: WHEN SEE THE PRE-ALARM LED IS ON FOR LOW BATTERY,
PLEASE RE-START THE CAR ENGINE TO MAKE IT WORK AGAIN.
WARNING! FLUORESCENT LAMP
DO NOT USE THIS DEVICE WITH FLUORESCENT LAMPS.
EN
4