RND power RND 320-00160 Bedienungsanleitung Seite 3

DON' T MODIFY OUR CABLE ACCESSORY.
WHEN CONNECTED TO ANY APPLIANCE, BE SURE TO CONNECT THE
CIGARETTE PLUG FIRST. AND THEN TURN ON THE POWER SWITCH OF
THE APPLIANCE.
WHEN THE INVERTER OPERATES IN FULL OUTPUT CAPACITY FOR A
LONG PERIOD, THE TEMPERATURE OF THE INVERTER WILL INCREASE
AND POTENTIALLY SHUT DOWN BY THE OVER-TEMPERATURE
PROTECTION. THEREFORE, IT IS RECOMMENDED TO REDUCE THE
AC OUTPUT CAPACITY IF A LONG CONTINUOUS OPERATING TIME IS
REQUIRED.
3
EN
Condition
Input Over Voltage
Low battery alarm:
Overheating alarm:
Overload alarm:
Note: BI is a short beep, and BEE is a long beep.
DURING OPERATION, WHEN THE POWER SWITCH IS ON, IF POWER ON NDICATOR
IS NOT LIGHTED. PLEASE CHECK THE FUSE IN THE CIGARETTE PLUG. IF THE FUSE
IS SPOILT, FOR REPLACEMENT, USE THE SAME CURRENT FUSE.
WHILE USING USB PORT: OUTPUT 5VDC (2.1A MAX) FOR CHARGING,
PLEASE CONNECT THE CIGARETTE PLUG FIRST, THEN CONNECT THE USB
WIRE TO THE ELECTRONIC APPLIANCE THAT NEEDED TO BE CHARGED
WARNING: WHEN SEE THE PRE-
ALARM LED IS ON FOR LOW
BATTERY, PLEASE RE-START THE
CAR ENGINE TO MAKE IT WORK
WARNING SIGNAL (THE RED LED INDICATOR)
Warning signal cycle
No Warning Signal
BI BI BI (pause)
BI BI (pause)
BI BI BI BI BI BI(continuous)
WARNING FLUORESCENT LAMP
DO NOT USE THIS DEVICE WITH
FLUORESCENT LAMPS.
AGAIN.
EN
Shutdown signal cycle
BEE BEE BEE BEE
BEE BEE BEE (pause)
BEE BEE (pause)
Continuous tone
4