Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating manual: TD357 RC movement, transmitter DCF77
Product features:
·
Radio-controlled and DST automatic switching
·
Perpetual calenda
·
Time zone setting
·
Up to 3 years long battery life, depending on usage
·
LCD display with day/date display in German or English, Signal reception, digital time, Stopwatch
·
Battery Type: shown on case back (CR2016, lithium manganese dioxide)
LCD Display
Press S1 to switch between several functions:
Date + Day – Signal reception and digital time – Stopwatch – RS Mode for initial setup
1. Initial Setup
(important for correct setting of radio-controlled watch)
Due to heavy shocks or magnetic
hands with the
Internally saved radio time.
·
Press S1 (possibly several times) to go to Initial Setup mode (RS 00:00 ).
·
Press S3 and hold for 6 seconds until the second hand rotates.
·
Hands will rotate to 12:00. Please be patient until all hands stop running.
·
Press S3 stepwise to set all hands on 12:00 (if needed).
·
You can press S3 for 6 seconds to re-activate auto run. Press S3 again short to stop auto run before 12:00 position. After that, press S3 stepwise for calibration exactly on
12:00-position for all hands.
·
All hands are positioned on 12h. The watch will be automatically adjusted to standard time. This procedure will take around 3-8 Minutes. Please do not press any button while
hands calibration
is in process.
2. Checking Radio Reception
The radio clock will attempt to receive the DCF77 radio-control signal every day between 2:00 and 3:00. However,
interference with reception might occur due to Thunderstorms or electrical disturbance.
·
Press S1 (possibly several times) to go to time mode ,The LCD display shows Signal symbol
was not successful.
3. Manual Radio Reception signal
A manual call for the transmitter is always possible, but might fail due to bad weather conditions or electronic devices in the vicinity.
·
Press S1 (possibly several times) to go to time mode.
·
Press S1 and hold for 3 seconds.
·
The second hand rotates to 12:00, The LCD display shows the signal reception. The process will take 3-8 minutes.
4. Language settings
·
Press S1 (possibly several times) to go to date mode
·
Press S3 and hold for 3 seconds until the LCD display shows DE (German) or EN (English).
·
Press S1 to choose.
·
Press S3 to store.
5 . Time zone setting and DST setting
By adjusting the time zone, your watch can display the correct time in other countries. Please adjust the time zone prior to your travel.
·
Press S1 (possibly several times) to go to time mode .
·
Press S3 and hold for 3 seconds until the display shows EU.
·
Press S1 to choose.
·
Press S3 to store.
Attention – following function is only available due
summer time (DST):
You can now switch between DST „ON" / „OFF" by
pressing S1. This causes as not all time zones have
DST.
After you completed your settings, please press S3
once to quit.
6. Stopwatch
·
Press S1 (possibly several times) to go to stop watch mode (00 00:00 STW).
·
Press the S3 button to start counting steps，Press S3 again to pause step counting.
·
It can be reset by pressing S1 button after the stopwatch pauses,
·
Press S1 button again to exit stopwatch mode.
Note: You can find information about water resistance and Instructions for environmental protection in the 'General Information' sheet.
Declaration of Conformity
Trend News Europe GmbH hereby declares that the devices are in accordance with the essential requirements and other relevant provisions of Directive 2014/53. The complete
declaration of conformity can be obtained from: office1@tneurope.de/ https://www.time-expert.de/vergleichitaetserklaerung.
This product complies with the EU EMC guidelines.
Trend News Europe GmbH, Eichholzer Str. 3c, D-21436 Marschacht
fields,
the hand position may differ from the internally saved radio time. the initial setup serves to resynchronise the
(english/German)
.
the reception attempt was successful or
ENGLISH
No function
if it
TD357 12/2023
Werbung
