Functions Of The Switch; Technical Specifications - Massoth Dcc Bedienungsanleitung

manual)
Make sure to connect a pulsed smoke generator in the correct polarity:
the red cable must be connected to the pin marked „+"!
2.2 Installation
Remove the LGB on-board decoder and install the on-board adapter in
the same place where the decoder was with the same 3 screws.
Recommended decoders:
Massoth eMotion XL , XXL or XLS

2.3 Functions of the switch

After the installation the functions of the switch are changed as the
switch does not control the Massoth eMOTION decoder.
0 = Locomotive OFF
1 = Decoder ON with all functions
2 = Power plug ON (additionally)
3 = Additional track power plug in the middle of the adapter ON (2 pins)

3 Technical specifications

Operating voltage : 24V (DC or Digital)
•
max. Amperage : 3A (depending on the decoder used)
•
3.1 General and safety details
This is not a toy. Not suitable for children under the age of 14 years.
This product may have sharp corners and edges and may be harmful if
swallowed. Handling the item may cause restraint injuries. If not trained
properly do not handle this product; have a professional install this item.
Operate this product only with products posted in this manual. Technical
specifications and measurements are subject to change without prior no-
tice.
DCC Onboard Adapter – 8150701 8