Insulation Testing With An External 500V Insulation Tester (Not Included); Battery Replacement - Maxwell Digital Multimeters 25601 Gebrauchsanleitung

Frequency range
Overload protection
Displayed value
Distance between
clamps
Insulation Testing
With an external 500V insulation tester (not
included)
Threshold Resolution
20 MΩ 10 kΩ
Threshold Resolution
2000 MΩ 1 MΩ
Accuracy +/- 4.0% +/- 2d
Threshold Resolution
2000 MΩ 1 MΩ
Accuracy +/- 5.0% +/- 2d
AC Voltage
Threshold Resolution
200 V 100 mV
Threshold Resolution
750 V 1 V
Inward impedance
Frequency range
Displayed value
Overload protection
DC Voltage
Threshold Resolution
1000 V 1V
Inward impedance
Overload protection
Resistance
Threshold Resolution
4
200 Ω 0,1 Ω
50 Hz– 60 Hz
1200 A, 60 seconds
average, verified with a
sine (RMS)
a
5 cm
• Battery (9 V, 6F22 or NEDA 1604 type)
• Measuring wires (1 pair)
• User manual
b
Accuracy
If the "BAT" sign appears on the screen, the battery
+/- 2.0% +/- 2d
in the device needs to be replaced.
• Turn the device off and remove the measuring
Note
< 500 MΩ
• Remove the screw holding the battery container
• Remove the depleted battery and replace it to a
Note
• Replace the lid and screw it back in.
< 500 MΩ
Warning: Always make sure that the wires are
disconnected from any measured circuits before opening
the container lid. Close and screw back the lid before
using the device again.
Accuracy
+/- 1,0% +/-4d
Accuracy
+/- 1,0% +/-4d
9 MΩ
50 Hz–500 Hz
average, verified with a
sine (RMS)
750 V AC/DC
Accuracy
+/- 0,8% +/-2d
9 MΩ
1000 V AC/DC
Accuracy
+/- 1,0% +/- 3d
Threshold Resolution
20 kΩ 10 Ω
Overload protection
ccessories
attery replaceMent
wires.
lid, and remove the lid.
new one of the same type
Accuracy
+/- 1,0% +/- 1d
500 V AC/DC