Clas Ohlson ZK6311 Bedienungsanleitung

Flowers solar string lights
Art.no 36-6972 Model ZK6311
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
• Handle the product with care, making sure not to damage
the surface of the solar cell and ensuring that it is not
covered with dust or affected by other contaminants.
• The product must not be changed or modified in any way.
• Do not let children play with the product.
Note: The string light can also
be powered by a battery pack
or a mains adaptor (both sold
separately) which enables it to be
used all year round. Disconnect
the solar cell and replace it with
either a battery pack or mains
adaptor.
Responsible disposal
This symbol indicates that this product
should not be disposed of with general
household waste. This applies throughout
the entire EU. In order to prevent any harm to
the environment or health hazards caused by
incorrect waste disposal, the product must
be handed in for recycling so that the material
can be disposed of in a responsible manner.
When recycling your product, take it to your
local collection facility or contact the place of
purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
GREAT BRITAIN • customer service tel: 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet: www.clasohlson.co.uk postal: 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
Installing the solar cell
Pushed into the ground
1. Set the switch on the back of the solar cell to ON.
2. Attach the ground spike 3. Adjust the angle of the solar
to the solar cell and cell to receive as much
then push the spike into sunlight as possible.
the ground.
4. Hang up the string light in the desired location.
5. The string light comes on automatically at dusk.
Fastened to a structure
1. Detach the bracket from
the solar cell.
2. Using the bracket as a guide,
mark out the position of
the mounting holes.
3. Use an appropriate type of screw
or fastener for the material of
the structure. Note: Ensure that
there are no electrical wires or
water pipes in the wall where you intend to screw/drill.
4. Set the switch on the back of the solar cell to ON.
5. Screw the solar cell back onto the bracket and adjust it to
an angle to receive as much sun as possible.
6. Hang up the string light in the desired location.
7. The string light comes on automatically at dusk.
Care and maintenance
• Clean the exterior of the string light by wiping it with
a damp cloth. Use only mild cleaning agents, never solvents
or corrosive chemicals.
• Replacing the battery:
1. Remove the 4 screws 2. Change the battery (1 × 1.2 V,
on the back of AA 600 mAh NiMH) making
the solar cell. sure the new battery is
inserted with the correct
polarity, see the picture above.
Note: The battery must
only be replaced with
a rechargeable battery.
Specifications
Length 7.3 m, of which 3.8 m with bulbs
Charging time 6–8 hours (in continuous sunlight)
Approximately 8 hours
Operating time
(when fully charged)
Rated life 20000 hours
1 × 1.2 V, AA/HR6 600 mAh NiMH
Rechargeable battery