ring PowerSourcePure REINVPA6 Bedienungsanleitung Seite 5

Setup Mode
The inverter can be configured by entering the setup mode
To enter Setup Mode press & hold
Press keys to select item then press
Adjust setting using
Press and hold key to exit back to Information Mode
Output Voltage
Last Error Code
Battery Size
Power Saving Mode If the inverter does not detect a load for 10 minutes it will enter a sleep mode to
Low Voltage Cut-Off Sets the voltage at which the inverter will switch off should the input voltage
Output Frequency
key
then press
Output Voltage
Last Error Code
Battery Size
Power Saving Mode
Low Voltage Cut-off
Output Frequency
Sets the AC output voltage. Only change if the application requires a different
voltage for optimum performance
Allows the last error code to be viewed
Sets the Ah rating of the battery supplying the inverter. The value is used when
calculating input current and hours remaining in conjunction with the Current
Sensor
reduce drain on the battery. In this mode the power indicator will flash green
become too low
Sets the output frequency of the inverter. Only change if the application requires a
different frequency for optimum performance
, chosen setting will then flash
to set
Setting
200/220/230/240V
N/A
90 – 540Ah
(in 30Ah steps)
ON/OFF
9-5 – 11.0V
(in 0.5V steps)
50/60Hz
GB
Default
230V
N/A
90Ah
ON
10.0V
50Hz