Harman JBL DA1650 Kurzanleitung

ENGLISH
DA1650
Quick Start Guide
Overview
Thank you for purchasing a JBL DA series distribution amplifier. The DA1650
is designed, engineered, and manufactured to the industry's highest quality
standards and offers system integrators with the core features and fundamental
connectivity for home audio distribution.
For more information on the set-up and operation of this product refer to the
product page on the jbl.com website. Should further assistance be required feel
free to contact customer support at the numbers below.
Inside the US and Canada: +1 888.691.4171
Outside the US and Canada: +44 1707 668 012
Installation
RACK MOUNTING
CAUTION: Before you begin, make sure your amplifier is disconnected from the
power source.
The DA series amplifiers are intended to be installed in a standard 19-inch
equipment rack with the supplied with rack mount ears in a 1U rack space (rack
mount bolts are not included).
Installing a DA series amplifier in a rack:
1. Attach the rack ear brackets to the sides of the amplifier using the provided
machine screw fasteners into the threaded holes.
2. Install into rack and connect cabling.
PROPER COOLING
Air flow is side-to-side.
When using an equipment rack, mount units directly on top of each other. Close
any spaces in the rack with blank panels. (Open spaces will reduce cooling
efficiency.)
Once mounted in the rack, ensure the sides of the amplifier are well ventilated
and fan openings are not obstructed. The rack should be a minimum of 2 inches
(5.1cm) away from the sides of the amplifier.
SURFACE MOUNTING
You can also place a single amp on a solid, stable surface utilizing the provided
feet and fasteners.
Once positioned, ensure the sides of the amplifier are well ventilated and that
the fan openings are not obstructed.
If the system is taken out of use for a long period, disconnect the amplifier from
the mains power supply.
Wiring and Connections
CONNECTING AUDIO INPUTS
JBL recommends using pre-built or professionally wired unbalanced cables
(single-ended plus shield). The DA series amplifiers accept line-level audio
connections at the RCA input connectors.
When the amplifier is used as a multi-zone amplifier, each channel can be
provided with a dedicated input signal. The signal from this input will be
available on the corresponding speaker-level output.
Alternatively, each zone can be linked individually to the GLOBAL IN/ZONE
INPUT 1 by moving the dip switch up for that zone to the ON position.
DA1650 Quick Start Guide | rev1.3 20231012
©2023 Harman International | Features, Specifications, and Appearance subject to change without notice.
Box Contents
1x JBL DA1650 Amplifier
1x Quick-start guide and safety sheet
8x Phoenix block connectors
4x Removable feet and fastening screws
2x Rackmount brackets and fastening screws
1x Power Cord
Pg 1 of 2