HELIX PURE R Serie Bedienungsanleitung Seite 13

Connecting the Flex-Crossover
Option 1: Mounting positions within close proximity
Connecting the crossovers in vehicles with mounting positions of tweeter and woofer close to each
other, e.g. in the car door.
Head unit /
amplifier
Option 2: separate mounting positions
Connecting the crossovers in vehicles with separate mounting positions of tweeter and woofer, e.g.
tweeter in the A-pillar and woofer in the car door.
1. Press the acrylic covers to-
gether with slight pressure
and pull them off towards the
top.
Press Press
Press Press
4. Reinsert the circuit boards in the carrier plate and screw them back in place with the previously loos-
ened screws. Then connect the loudspeakers and signal source.
5. At least, reinstall the acrylic covers. Do not install the circuit boards without the housing. Risk of
circuit!
2. Remove the two jumpers and
the 4 screws (red marked).
Then fold the circuit board in
the middle into two parts.
Head unit /
amplifier
or
3. Pull the carrier plate apart to
the side.
or
en
13