HELIX PURE R Serie Bedienungsanleitung Seite 10

General instructions
General instructions for connecting HELIX
speaker systems
We strongly recommend that you operate the
complete audio system at low volume before fi-
nal installation. So you can check whether each
speaker is working before securing the loudspeak-
ers into their mounting locations.
Make sure that all speaker wiring is fully protected
from cutting or wear at sharp edges, which can
lead to short circuits that may damage your head
unit, amplifier and/or speaker system.
Make sure that all speaker wires are long enough
in order to avoid any mechanical stress on the
wires or the connectors.
Attention: Ensure that the loudspeakers are cor-
rectly connected (phase), i.e. plus to plus and
minus to minus. Exchanging plus and minus will
result in a significant loss of sound quality.
The positive leads of the loudspeaker system are
marked with a white lettering.
General instructions for connecting the HELIX
"Flex-Crossovers"
The crossover of the PR K165.2 component kit
offers two configuration options.
Option 1: Connecting the crossovers in vehicles
with mounting positions of tweeter and woofer
close to each other, e.g. in the car door.
10
CROSSOVER
Option 2: Connecting the crossovers in vehicles
with separate mounting positions of tweeter and
woofer, e.g. tweeter in the A-pillar and woofer in
the car door.
TWEETER
CROSSOVER
WOOFER
CROSSOVER
For further information regarding the connection
of the crossovers see section "Connecting the
Flex-Crossover" in this manual.