Werbung
Steps
1. Remove the (#6-32) screw that secures the 2.5-inch hard-drive assembly to the hard-drive and optical-drive bracket.
2. Disconnect the data and power cables from the connectors on the hard drive.
3. Lift and slide the 2.5-inch hard-drive assembly away from the hard-drive and optical-drive bracket.
4. Turn over and place the 2.5-inch hard-drive assembly on a flat surface.
5. In a reverse sequential order (4>3>2>1), remove the four (#6-32) screws that secure the 2.5-inch hard drive to the hard-drive cage.
6. Slide and remove the 2.5-inch hard drive from the hard-drive cage.
Installing the 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the 2.5-inch hard drive and provides a visual representation of the installation procedure.
Steps
1. Align and slide the 2.5-inch hard drive into the hard-drive cage.
2. In a sequential order (1>2>3>4), replace the four (#6-32) screws to secure the 2.5-inch hard drive to the hard-drive cage.
3. Align and slide the hard drive assembly into the hard-drive and optical-drive bracket.
4. Replace the (#6-32) screw to secure the 2.5-inch hard drive assembly to the hard-drive and optical-drive bracket.
5. Connect the power cable and data cables to the connectors on the 2.5-inch hard drive.
Next steps
1. Install the
front
cover.
2. Install the
left-side
cover.
3. Follow the procedure in
Entfernen des 3,5-Zoll-Festplattenlaufwerks
Voraussetzungen
1. Befolgen Sie die Anweisungen unter
2. Entfernen Sie die
linke
Abdeckung.
3. Entfernen Sie die
vordere
Info über diese Aufgabe
Die nachfolgende Abbildung zeigt die Position der 3,5-Zoll-Festplatte und stellt das Verfahren zum Entfernen bildlich dar.
After working inside your
computer.
Vor der Arbeit an Komponenten im Inneren des
Abdeckung.
Computers.
Entfernen und Einbauen von Komponenten
15
Werbung
