Overview Of The Components; Initial Operation - Clatronic GS 3656 Bedienungsanleitung

Overview of the Components

1 Facial sauna attachment
2 Base
3 Rotary switch
4 Heating indicator lamp
5 Mouth and nose inhaler
6 Aroma attachment
7 Measuring cup
Notes on Use
The facial sauna is used for cosmetic face care and inhalation.
The application of the facial sauna attachment opens up the
pores for better cleaning. In addition, it moisturizes the skin
and stimulates the blood circulation. For example, specific
application of essential oils ensures healthy inhalation.
WARNING:
• The maximum treatment time should be no longer than
20 minutes!
• We recommend that you use the appliance 2 or 3 times
a week at the most.
Accessories
• Treat your entire face with the facial sauna attachment.
• If you wish to add oils or additives, apply a few drops on a
cotton pad. Put this in the aroma attachment.
WARNING: Risk of scalding!
Never fill oil or other additives directly into the water
tank! As the water evaporates faster, the oil may start
to squirt.
• If you wish to deliberately inhale through the mouth and
nose, use the inhaler.
Electrical Connection
• Before inserting the plug into the socket, make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the appliance to a properly installed earthed
socket.

Initial Operation

CAUTION:
Do not exceed the MAX marking on the water tank! For this
purpose, use a measuring cup.
WARNING:
• Before cleaning remove the mains lead from the socked.
GS3656_IM
1. Fill the water tank on the base with clean tap water.
NOTE:
Fill as much water as is needed only. The more water
you fill, the longer is the inhalation time.
2. Fit the facial sauna attachment on the base. Insert the
lugs into the guide and turn it in towards
3. Put a cotton pad with additives in the aroma attachment
as needed. To do this, open it at both locking lugs.
4. Fit the aroma attachment in the facial sauna attachment.
In doing so, check the lug position. Turn it clockwise to
secure.
5. If you wish to use the inhaler for mouth and nose, fit it
on the aroma attachment. To do so, use the recesses on
the inhaler.
1. Set the appliance onto a non-slip, level surface.
2. Insert the mains plug into the socket.
3. Set the rotary switch to position 2.
NOTE:
The control lamp indicates the heating process. The heat-
ing time is approx. 3 minutes. The water starts boiling.
4. Always set the rotary switch to position 1, before you begin
the treatment. Extremely hot steam could hurt your face.
WARNING:
Keep a safety distance of at least 10 cm! If the temperature
of the vapor gets too high, increase the distance.
5. Keep your face above the facial sauna attachment, or
keep your nose and mouth on the inhaler.
When you have finished using the Device
1. After treatment, set the rotary switch to position 0 to turn
off the appliance.
2. Disconnect the mains plug from the socket.
3. Let the device cool down completely.
4. Pull the inhaler off in upward direction.
5. Turn the aroma attachment counterclockwise to remove it.
6. Remove the facial sauna attachment by turning it towards
.
7. Pour the remaining water from the water tank. Then dry
the tank using a cloth to avoid lime deposits.
Cleaning
.
Operation
18.07.16
29