Overview Of The Components - Clatronic WUB 3144 Bedienungsanleitung

Overview of the Components

1 Control
2 Thermostat
3 Control lamp
Instructions for Use
Use
Use the electric blanket on the mattress of your bed. The electric
blanket must be attached to the mattress by means of the straps.
• Place the electric blanket on the mattress (see Figure A).
• Release the straps and guide them under the mattress (see
Figure B).
• Pass the straps through the loops on the other side of the
electric blanket and fasten them with knots.
• The electric blanket must lie smoothly on the mattress and
must not be tucked in or contain any creases.
• Pass the lead out of the bed in such a way that you can still
operate the thermostat.
WARNING:
Under no circumstances should the thermostat be covered
by bedding or cushions! Otherwise this might result in a
malfunction.
Electrical Connection
• Please ensure that the device voltage (see type plate) and
mains voltage are the same.
• Insert the mains plug into a properly installed 230 V, 50 Hz
socket with earthing contact.
Switching on
• Move the regulator on the thermostat (2) to the desired
setting.
• The control lamp (3) lights up and shows that the device is
working.
NOTE:
On the fi rst few occasions that this device is used unusual
odours may be produced. These are harmless and disappear
the more the device is used.
Thermostat Settings
You can select from the following settings:
Setting Function
0
Off
Low. Slight
1
warmth.
2 Medium
3
High
26
05-WUB 3144 26
Switching off
•
•
Always remove the mains plug from the socket before cleaning
the device.
•
•
•
•
•
•
Removing Stains from the Electric Blanket
•
•
Drying the Electric Blanket
•
•
•
The electric blanket must be completely dry before it is used
again.
Thermostat
•
Storage
Instructions for Use •
•
Suitable for operation
during the night.
Suitable for operation
•
during the night.
•
Not suitable for opera-
tion during the night.
Only for warming up
the bed before getting
into it
NOTE: You can read off the setting on the control lamp (3).
Turn the thermostat control to 0 (off).
Only then should you remove the plug from the mains
socket.
Cleaning
WARNING:
CAUTION:
The electric blanket together with the thermostat must not
be placed in the washing machine or dry-cleaned.
Do not immerse the components in water.
The thermostat must not be allowed to become wet.
If you use water to clean the electric blanket, this must not
be warmer than 30°C. Otherwise the material could shrink
and damage the electrical system.
Do not use any abrasive cleaners or solvents.
Do not use any stain remover such as foam or spray.
Wipe off the affected area with a damp cloth or sponge. In
the case of stubborn stains a gentle solution of soapy water
may be used.
Excess water can be dabbed off with a towel.
After cleaning, allow the material to dry in the air.
To this purpose the entire electric blanket should be hung
over a line.
Do not use any pegs or similar items.
WARNING:
You should only wipe off thermostat with a dry cloth.
Remove the mains plug from the socket and allow the
electric blanket to cool down for approx. 20 minutes.
Fold the electric blanket together gently and store the entire
product in the storage bag.
CAUTION:
Store the product in a dry place.
Do not place any heavy objects on the device.
06.03.2007, 9:55:26 Uhr