Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Specifications
Lens diametre
Focal length
Resolution
Photo format
Video format
Waterproof level
Cable length
Operating temperature
Endoscope Installation
Endoscope is a practical inspection tool necessary for inspection or maintenance work,
and is widely used in drainage pipe, air conditioning, wall circuit, home appliance
inspection, small opening observation, or automobile reparations.
To install the endoscope, first use a screwdriver to unscrew the upper screw of external
expansion port. Take out the uSmart connector cable, attach it to the uSmart expansion
port, and tighten the screw. Place the phone inside the phone holder (you can adjust the
height using the rotate switch), then connect the uSmart Type-C cable to the handle.
Remove the protective case. (If the endoscope has been installed correctly, the LED light
on the top of endoscope camera will light up.) Then you can use the endoscope.
After you uninstall the endoscope, you can choose to use the screwdriver to tighten the
previously removed screw or not (the screw hole is waterproof).
Notes
Do not use the snake tube camera with other manufacturer's endoscope parts
•
without authorization, even if the interfaces are the same.
Do not use the product in areas where it may be exposed to wires or charged
•
objects, as the exposed metal parts can conduct electricity and may cause
unexpected accidents.
Please do not allow minors to operate this endoscope independently, and it is
•
forbidden to use this device for medical purposes or human and animal testing.
Keep the product clean, avoid exposure to the sun, and prevent direct contact
•
with water, oil, and corrosive liquids.
6mm
4±2cm
1280×720
JPEG
MP4
IP67
1m
-10~60°C
4
Werbung
