Werbung
Verfügbare Sprachen
Verfügbare Sprachen
410115L
Mounting:
§ Put the plate and the clutch mechanism on the flywheel
§ Centre the disk clutch using one of the suitable pin supplied (Re. 8)
§ Insert the three legs with the right threading but do not tighten,
otherwise you can damage the SAC system
§ Install the special clamp tool and lock it with the M8 locking knobs.
Please note that the bell is not connected to the flywheel.
§ Rotate the special tool's handle to compress the cup spring totally.
Now the bell is close to the flywheel.
§ Place and tighten the clutch's locking screws to the flywheel.
§ Release the pressure of the tool, and remove all parts.
§ Mount now the remaining three screws and finish the operation.
www.swstahl.de
SW-Stahl GmbH
Leverkuser Strasse 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-mail: info@swstahl.de
Werbung
