cecotec DRUMFIT CROSSFIT 3000 EOLO Bedienungsanleitung Seite 60

Verfügbare Sprachen

ENGLISH

Spring washer Ф6

Tension bracket

Tools and hardware

Spanner with Philips screwdriver S13-S14-S15 (x1). Fig. 2

Spanner S10-S13-S17-S19 (x1). Fig. 3

Allen key S6 (x1) Fig. 4

Allen key S5 (x1) Fig. 5

(20) Axle (x2). Fig. 6

(23) Wave washer ø26xø16x0.3 (x2). Fig. 6

(25) D-shaped washer ø28xø16x5 (x2). Fig. 7

(26) Washer ø10xø25x2.0 (x2). Fig. 8

(27) Spring washer ø19.5xø11.5x3 (x2). Fig. 9

(28) Bolt M10x20 (x2). Fig. 10

(29) Carriage bolt M8×40 (x4). Fig. 11

(30) Curve washer ø20xø8x1.5 (x4). Fig. 11

(31) Cap nut M8 (x4). Fig. 11

2. BEFORE USE

This device is packaged in a way as to protect it during transport. Take the device out

of its box and remove all packaging materials. You can keep the original box and other

packaging elements in a safe place. This will help you prevent damage to the device when

transporting it in the future. In case the original packaging is disposed of, make sure all

packaging materials are recycled accordingly.

Make sure all parts and components are included and in good conditions. If there is any

piece missing or in bad conditions, contact the Official Cecotec Technical Support Service

immediately.

3. PRODUCT ASSEMBLY

Step 1: Front and rear stabilisers installation

1. Remove two hex bolts M8x16 (15) and two flat washers Ф20xФ8x1.5 (38) from the front

stabiliser (7). Unscrew the bolts using the Allen key S6 provided.

2. Attach the front stabiliser (7) onto the main frame (1) with the two hex bolts M8x16 (15)

and two flat washers Ф20xФ8x1.5 (38) previously removed. Tighten the bolts using the

Allen key S6 provided.

DRUMFIT CROSSFIT 3000 EOLO

End cap Ф38