Xblitz Master ONE Bedienungsanleitung Seite 7

continuously for approximately three hours at medium volume.
04. DESCRIPTION OF THE MODES OF UR MANAGEMENT
1. Bluetooth mode
When the device is switched on, Bluetooth mode, which is the default mode
of operation, will automatically turn on. The speaker will confirm the activa-
tion of BT mode with a sound notificationand message on the display. Before
first use, pair the speaker with the selected device by activating BT connec-
tion on the latter and select XBLITZ MASTER ONE from the list. Successful
connection will be confirmed by an sound notification from the speaker.
To switch to the next song, briefly press the + button. To switch to the
previous song, briefly press the - button. To increase or decrease the volume,
hold down the + button or the - button respectively. Briefly press the M
button to switch the unit to FM mode.
During a phone call, the speaker will read out the caller's phone number,
then start beeping the incoming call. Briefly press the PLAY/PAUSE button
to answer the call or hold the same button to reject the call. Note: as the
selected speaker model is not equipped with a microphone when using
hands-free mode, you must use the microphone on your phone.
2. FM mode
To enter FM mode, briefly press the M button. For automatic programming
of radio stations, press the PLAY/PAUSE button. The unit will scan the frequ-
encies in the broadcast band 87.5 - 108 MHz and assign sequential numbers
to the available radio stations. These will be stored in the speaker's memory.
To switch between the preset radio stations, briefly press the + or - button.
Increasing and decreasing the volume is analogous to BT mode - by holding
down the + or - buttons.
Note: To improve the quality of radio reception, it is recommended to plug
the supplied USB cable into the micro-USB port on the device.
3. Clock and alarm settings
Clock and alarm settings are available in both BT and FM modes.
To set the clock, hold down the SET button, then use the + and - buttons
to set the current hour and briefly press the SET button to move on to the
minutes setting. Confirm the operation by holding down the SET button.
The unit allows you to set two alarms. To go to the setting of alarm 1, briefly
press the SET button. The SET1 icon will be highlighted on the display of the
unit. Then hold down the SET button and set the selected alarm time in the
same way as setting the clock. Another short press of the SET button allows
you to set alarm number 2 - SET2. The programmed set alarms can then be
7