sweeek. CAREMBAULT CPM2AT Bedienungsanleitung Seite 17

INSTRUCTIONS BEFORE ASSEMBLY
CHOOSING AND PREPARING A LOCATION
• The best location is one that is high up, allowing water to drain away. Find a location that is far
enough away from trees.
• Make sure that you assemble your dustbin cover on a dry, calm day. Do not try to assemble your
dustbin cover on a windy day.
• The installation area must be clean, clear and totally flat. A cluttered, damp or wet work area in-
creases the risk of injury. Make sure that there are no cables on the ground during assembly.
• Leave yourself enough work space to be able to move and position the components easily during
assembly. You must ensure that there is enough space at the entrance for the door(s) of your dust-
bin cover to open fully and around the dustbin cover in order to attach screws from outside.
• Before beginning the first steps to assemble the components, a foundation must be built and the
anchoring system must be ready.
FOUNDATION
• It is strongly advised to install your trash can cover on a base. To prevent wind damage, the frame
of your trash can cover needs to be strengthened. In addition, you must make sure that the metal is
not in direct contact with the ground, in order to avoid rust.
• Your trash can cover must be sturdily anchored to the ground to prevent wind damage. You also
need to build a solid foundation so that the trash can cover is level and straight. The materials nee-
ded to build the foundation are not included with your trash can cover. However, your product comes
with an anchoring kit, so that you can fix it to the ground.
• To build the foundation, we recommend a poured concrete slab or several large square concrete
slabs to be used as a base and the floor. Whichever option you choose, make sure that the foun-
dation is sturdy and allows water to flow away, so that it does not accumulate under the trash can
cover.
• You must ensure that you have all the materials required to build your chosen type of foundation.
The manufacturer accepts no responsibility for the choice and construction of the foundation.
PLEASE NOTE: Before pouring the concrete slab, you should first prepare a uniform layer of com-
pacted hardcore. You can then pour the concrete until reaching a thickness of 10 to 15cm. Leave
the concrete to set for at least 48 hours.
6/11/2023
EN
17