HELIX BT HD STREAMER Bedienungsanleitung Seite 34

6. Connection of the optional HELIX BT HD Hands-Free Microphone Kit
8. Activate hands-free protocol on the BT HD STREAMER
Set the hands-free protocol switch (HFP) to "on".
Note: Activation must be done when the device is switched off.
9. Reconnect mobile device
Start your sound system and activate the pairing mode of the BT HD STREAMER either with the pair pushbutton
(see page 23, point 5) or an external pushbutton. Connect your mobile device to the BT HD STREAMER accord-
ing to the instructions in this manual.
Note: Pairing is also required if your mobile device was previously connected to the BT HD STREAMER without
an active hands-free function.
10. Test connection
Check if the microphone is working properly by making a test call. Make sure that you can be heard and that the
audio quality is clear and distinct. If the test was not successful, check the cabling and all plug connections and
carry out the installation steps again. If the problem persists, contact your installation specialist for further assis-
tance.
34