Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
After completing the cut, power o the device and allow the saw blade (10)
to come to a complete stop. Do not remove the saw from the workpiece
while the saw blade is moving.
•
Clean and maintain the device after every use (see "Cleaning and
maintenance").
4) CLEANING AND MAINTENANCE
•
Clean the device after every use.
•
Switch the device o , make sure the saw blade (10) has stopped moving
and cooled down, and remove the battery pack (22) from the device.
•
Never immerse the device in water or any other liquid.
•
Clean the device with a dry cloth, use a brush for areas that are hard to
reach. If the device is extremely dirty, clean with a damp cloth and then
dry thoroughly.
•
Check the air inlet and outlet of the device for dust and dirt. Remove
dust and dirt carefully by vacuuming (vacuum cleaner).
•
Replace the saw blade (10) when it starts to wear, for optimal
performance and to reduce the risk of injury.
•
Never use aggressive or abrasive cleaning materials, a scouring sponge
or steel wool; these damage the device and will scratch and damage
the surface of the device.
•
Thoroughly dry the device.
•
Store the device in a dry place.
5) SPECIFICATIONS
•
Model: CCS20165
•
Rated voltage: 20 V DC
•
No Load Speed: 4300/min.
•
Saw Blade Size: 165 mm
•
Max. Cutting Capacity: 52mm at 90 degrees
•
Max. Cutting Capacity: 36mm at 45 degrees
•
Weight: 2.20 kg (without battery pack)
•
Dimensions without battery pack: 28 x 20 x 35 cm (H x W x D)
6) STORAGE & TRANSPORTATION
•
When storing the device, it should first be cleaned in accordance with
this user manual. The device should be stored in its original packaging.
•
Always store the device in a dry and well-ventilated room and beyond
the reach of children.
•
Protect the device against vibrations and shocks during transport.
All contents and specifications mentioned in this manual are subject to
change without prior notice.
INSTRUCTIONS FOR PROTECTING THE ENVIRONMENT
(WEEE,the waste electrical and electronic equipment directive, applicable
in EU member states)
Your product has been manufactured using high quality
materials and components which can be recycled and used
again. At the end of its service life, this product cannot be
disposed of in normal domestic waste, but must be taken to a
special collection point for recycling electrical and electronic equipment.
This is indicated in the user manual and in the packaging by the crossed-
out wheeled dust bin symbol. Used raw materials are suitable for recycling.
You can ask your local competent council about the location of your
nearest collection point.
By recycling used appliances or raw materials, you are playing an
important role in protecting our environment.
Correct disposal ensures that waste electrical and electronic equipment
(which may contain hazardous substances) is recycled and reused
appropriately. It helps avoid potential damage to the environment and
human health, wildlife and to preserve natural resources.
Batteries:
Do not dispose batteries in your household waste. Dispose of batteries by
taking them to your local recycling station. Contact your local competent
government o ices for details.
Following information is only valid for EU member states.
If the battery contains higher values of lead (Pb), mercury (Hg)
and/or cadmium (Cd) than defined in the Battery Directive
Pb, Hg, Cd
(2006/66/EC), the chemical symbols Pb, Hg and/or Cd are shown below the
crossed-out wheeled dust bin symbol.
Mascot Online B.V.
Veluwezoom 32
1327 AH Almere
The Netherlands
www.mascot-online.nl
4
Werbung
