Herunterladen Inhalt Inhalt Diese Seite drucken

elv Schouw Kamin Maxx Gebrauchsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

p In order to ignite the bioethanol, which has been filled, please proceed as
described under "Operation". Do not directly ignite the bioethanol!
p Never pour bioethanol onto an active fire or in the fire compartment if it is still
hot.
p Never extinguish the fire with water! To extinguish the fire, always proceed as d
described under "Operation".
p Immediately wipe up any spilled bioethanol and then wipe the affected area again
using water so there is no risk of it accidentally igniting.
p Do not smoke, eat or drink while filling the fireplace.
p Never additionally fan the fire (e. g. using a hair dryer).
p Always store the bioethanol in a sealed container, which is designated for this.
p Due to the high flammability of bioethanol, the place of storage must be cool, not
exposed to direct sunlight, and away from intense heat sources or open flames.
The stored quantity of 5 litres should not be exceeded in your home.
p Walls and ceilings with a u-value of less than 0.4 W/m2K must be additionally
guarded by means of suitable manners (the u-value represents a heat transmission
coefficient, which describes the heat transmission through a material layer when
two different temperatures are present on either side of such a layer).
Danger of burn
p The product and its components become hot during use and also remain hot
for some time after the fire has been extinguished. Allow the product to cool off
completely before you touch it.
Safety notices specific to the product
p Only use the fireplace in rooms of adequate size. The room sizes should amount
to no less than 44 m
height of 2.20 m.
p Only hang the product on even, solid, and non-flammable wall areas. For this, the
distance from the floor should amount to no less than 60 cm.
p When installing the fireplace, seek the assistance of a second person as the
product is heavy and difficult to handle.
The enclosed mounting material is intended for solid masonry. If you are not sure
p
as to whether the enclosed mounting material is suitable for your wall, seek
advice at a qualified outlet prior to installing the fireplace and if applicable,
exchange it.
During installation, ensure that no pipes or other lines run behind the intended
p
drilling point.
With respect to setup and use, compliance with national regulations and local
p
provisions is to be observed and practiced.
, which corresponds to a floor space of 20 m
3
18
with a room
2

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Kamin maxxFireplace kamin maxx

Inhaltsverzeichnis