HEIDENHAIN BC 110 BF Austauschanleitung Seite 24

Installation
Mounting the screen
Attach the enclosed seal all around the rear edge of the front panel of the replacement unit
Connect the ribbon cable (X8, 9-pin, male) of the soft-key row to its counterpart in the screen housing
Connect the 15-pin, male, three-row connector of the enclosed adapter cable to X1 on the BC 110BF
Connect the 15-pin, male, double row connector of the enclosed adapter cable to the signal line in the screen housing
Connect the power cable to X0 on the BC 110BF
Make sure that the positions of the DIP switches are correct
(see table below)
Insert the BC 110BF into the screen housing
Insert all fastening screws into the corresponding holes of the front panel and tighten them
(observe the torque specified by the machine manufacturer)
Settings of the DIP switches
1 2
off off
24
DIP switch S1
3 4
off off
5 6
off off
Switch 2
GND≠PE