ProPlus 367828 Gebrauchsanleitung Seite 7

Take down the installation
1) Drain the party tent by turning the drain valves (fig 7). To deflate the party tent, the middle ring must be
loosened (fig. 3, part B)
2) Remove all pegs and oosen all guy lines
3) Fold and roll towards the opened valves. This leaves the remaining air out
4) Fold up the party tent, place in the carrying bag and zip it closed.
MAINTENANCE
• Fully vent the party tent and make sure it is completely dry before it is packed
• Store in a well-ventilated dry place
• Do not wrap the party tent wet / damp to prevent mold Clean with water and a soft brush DO not use
cleaning agents and do not scrub hard
• The partytent requires no maintenance but must be protected against damage during storage
• Damage as a result of improper use, wind damage or neglect is not covered by the warranty
• Have any damage repaired at the first opportunity
FIRE AND VENTILATION
• If using gas or other combustion appliances additional ventilation is required
• Do not place hot appliances near the walls, roof or curtains
• Always observe the safety instructions for these appliances
• Never allow children to play near hot appliances
• Keep exits clear
• Make sure you know the fire precaution arrangements
• Make sure ventilation openings are open all the time to avoid suffocation
PRECAUTIONS
on the side
7